Alligator FPV

AlligatorFour


Price : $ 69.88

Propeller size : 5"



Description

Main design elements:

- sandwich bottom plate design like most modern quadcopters have

- thick 6mm arms for robustnes, all the same length and therefore interchangable

- rounded corners to reduce notch effect

- lot of space for mounting electronics: 3x 30.5mm and 20mm stack holes, in the front, in the middle and in the back

- rectangular holes in the topplate to fit XT60 connector trough. So power cables can't get into the props.

- holes for cable ties as strain relief for power cables in front and behind the center stack

- cavity for capacitor under center stack to save space and get it out of the way for wiring

- all action camera mounts for TBS source one will fit because of same mounting hole pattern

- slamdeck design to lower center off mass with 28mm spacers in the front, 20mm in the back.

- camera side plates to mount 19mm micro-size cameras

- frame wheight: 138g including hardware.

Photos:

How does it fly?

 

Check out my flight video:

Armattan Productions does not offer 3D printed elements. But you can print them yourself:

GPS mount: https://www.thingiverse.com/thing:4811321

VTX antenna mount: https://www.thingiverse.com/thing:4811357

VTX and CRSF antenna mount: https://www.thingiverse.com/thing:4811345

VTX and GHST antenna mount: https://www.thingiverse.com/thing:4811352

Why is it called "Alligator"?

This came up during the construction. When I looked onto the bottom plate in the CAD system it lookes like the mouth and body of an alligator. When you fly it together with other people this flying predator might eat some little tiny whoops ;-).

 

Review Section ( Total Review:0 )

No Review Found