1. Home
  2. Shop
  3. NF 3D Design
  4. Nico Fietkau

Nico Fietkau

Image

Contact Designer

.....
Image

NF 3D Design

Visit Store

Kits

  • Kit
    More Details

    Underdog5 Race Frame
    $ 35.00

    The Underdog5 is a 5 inch true X racing frame I designed.

    The arms interlock with a special heartpiece which stops them from wiggeling. The tolerances between the heartpiece are very tight so it might be pretty hard putting it together for the first time. If it is too tight you can always the heartpiece down a tiny bit.

    The stackscrews are only connected to te midplate and the arms have a slot for the screwheads so changing an arm does not affect them.

    It is 200mm from motor to motor which makes it very compact but does not give you any trouble with the props beeing super close.

    The weight should be around 70g fully assembled according to Fusion360s calculations but I am going to weigh it when it arrives.

    The arms provide protection for the motors without too much weight.

    The frame is designed to be light and strong and changing the arms only requires taking out 1 screw and loosening the middle one and leaves all your stack screws in place.

    • 5mm arms and heartpiece and 2mm mid, top and bottom plate
    • Accepts standard M3 30,5x30,5mm stacks as well as M3 20x20mm mini-stacks and M2 25.5x25.5mm whoop style boards
    • Comes with 20mm and 25mm standoffs so you can either run it a but lower with an aio board and the vtx on top or use the 25mm standofs and have plenty of room for a full stack

    As Armattan does not offer M3x10mm countersunk screws you have to buy them seperat. You need 5 and I strongly recomend steele screws because they hold the arms in place.

    If you want to go as light as possible you can also get aluminium or titanium screws for all the other screws and save a couple grams.

    The frame includes 16 M3x8mm motor screws because the arms are 5mm and it is a pain if your motors do not come with the right screw lenght.

    If you decide to build the frame I would love to see some fotos of it or if have any suggestions or questions feel free to email me at itsnickfpv@gmail.com

  • Kit
    More Details

    Brush5.5 5.5 inch
    $ 49.99

    The Brush5.5 is a 5.5 inch true X freestyle frame I designed.

    It is 245mm from motor to motor which allows for some extra room when running 5.5 ich props and a super stable quad when running 5 inch props.

    And weighs only 88g fully assembled.

    The Arms are inspired by Kababs Floss design because I think they provide good protection for the motors without too much weight.

    The frame is designed to be light and strong and changing the arms only requires taking out 2 screws and leaves all your stack screws in place.

    • 5mm arms and 2mm main, top and brace plate
    • Accepts standard M3 30,5x30,5mm stack as well as M2 20x20mm mini-stack
    • Four additional mounting holes (M2 20x20mm) for a second stack in the rear or if you want a Caddx Vista in the back or run your ESC in the middle and the FC in the rear
    • Comes with 20mm standoffs to keep the CG low but you can always use longer ones if that is not enough space for you

    3d printed GoPro session mount:

    https://www.thingiverse.com/thing:4772198

    3D printed GPS mount:

    https://www.thingiverse.com/thing:4791252

    3D printed micro size FPV cam mount:

    https://www.thingiverse.com/thing:4791256