2.5 inch version of the 3 inch 8bit frame

for 25mm m2 standoffs

made a mistake and got top plate 3mm thick, needed 2mm

updates file

SMA nutter- Not sure how well this will work, thought I'd try

new update strengthening the frame a bit

96mm simple frame for use with 66mm props and 11XX motors

Supports 16x16 flight controller

Use this camera mount: https://www.thingiverse.com/thing:2350617 

Shapeways: https://www.shapeways.com/product/TAKYUM3UE/pepperf1sh-camera-mount?key=ccb0b3bfef9595359c8114e46323dac4

1mm frame was too flimsy, trying a 1.5mm frame

96mm pepperF1sh frame for quadcopter. Last version had little motor protection. This one has some protection for the motors, should weigh in about 3g. Choose to have skinny arms and 1.5mm frame for strength.

Supports 16x16 flight controller

This one has been tested and crashed a few dozen times and has held up guite well.

X-frame built for 8.5x20mm coreless motor with F3 brushed board.

55mm props with possibility of 66mm depending on height of standoffs used and camera mount options. 

See my thingiverse for images of quadcopter: https://www.thingiverse.com/thing:2350677?