Quad frame in 1mm CF for 6mm brushed motors and H8 mini FC. New motor hole size is 5.85mm vs the 6mm motor hole size of the original CF677 currently for sale. Side lugs for rubber bands were added after a suggestion by RCGroups member Denovich (thank you!). This frame has not been checked and built as far as I know, so buy it at your own risk, it is listed at cost price. The design is near identical to the other CF677 frame.

BEWARE - if you buy this frame the 6mm motors you have will not just slide in, you will have to remove approximately 3 thousandths of an inch (0.07mm) from the inside of the motor mount holes to achieve the motor fit that you want. Suggested tools/methods are a fine round file, or 400 wet and dry sandpaper wrapped around a pen or suitable sized wooden dowel rod. Beware of carbon fibre dust, it is bad for your lungs. Do it under a running tap or use suitable protective gear.

Flight controller: 

The H8 mini green pcb can be flashed with silverxxx firmware to enable acro (rates) or level mode:
https://github.com/silver13/h8mini-testing

The H101 pcb can be flashed with silverxxx firmware from here:
https://github.com/silver13/H101-acro
The instructions are here in the first post:
http://www.rcgroups.com/forums/showthread.php?t=2512604

The H8 mini blue pcb can be flashed with silverxxx firmware from here:
https://github.com/silver13/H8mini_blue_board

For the CG023 and other FC's using the STMF031K4 processor the code is here:
https://github.com/silver13/CG023
The instructions are here in the first post:
http://www.rcgroups.com/forums/showthread.php?t=2634611#post34381034

These flashed FC's can be flown with a stock tx or Bayangtoys X9 tx, but it is a much better experience to use a Devo tx that is compatible with Deviation firmware, and fit it with a nrf24L01 module. Or you can use any other hobby grade tx (with a PPM trainer port) with a Goebish multiprotocol module, or you can build a multiprotocol module yourself.

Visit the Silverware wiki for more info on silverware:
http://sirdomsen.diskstation.me/dokuwiki/doku.php