Personal projects that others might enjoy.
Please note that these are purely diy projects. I do not deliver support but if you have any questions I will try to answer them.
Made for the 65mm kingkong props that Kababfpv recommends. This has the M2 triangle motor hole pattern!
M2 version designed by Arsalan
If you are looking for something that uses the m1.4 pattern of the trashcan/mobula motors I also have made those: https://armattanproductions.com/pages/product_details/19497
These are my tips:
- the fc aio board is 25.4mm~
- Camera mount that you can buy: Beebrain v2 camera mount
- Camera mount that you can print in tpu: https://www.thingiverse.com/thing:3429924
- Check out kababfpv's website/blog: https://kababfpv.com/
This was for me a personal project so I am not responsible if you have different results. That being said have fun with it!
I made the file open source so you can 3d print it if you want to test if it would work for your build. For all file sizes for the design: https://a360.co/2T1pAsI
Review Section ( Total Review:0 )
No Review Found