Conversion frame originally made for the trashcan. Made for the 65mm kingkong props that Kababfpv recommends. You will need your own hardware for the motors and I recommend looking into this well before you order.

These are my tips:

• Motor mount is the standard 080x motors with a screwhole size of m1.4 screws (like the trashcan) -> tiple hole 6mm diameter m1.4 mount
• the fc aio board is 25.4mm~
• Camera mount that you can buy: Beebrain v2 camera mount
• Camera mount that you can print in tpu: https://www.thingiverse.com/thing:3429924
• Check out kababfpv's website/blog: https://kababfpv.com/

This version is cut along the weave and therefore a few dollars more expensive.

This was for me a personal project so I am not responsible if you have different results. That being said have fun with it!

Might work fine with the Mobula 7, but I cannot know until someone tries it.

I made the file open source so you can 3d print it if you want to test if it would work for your build. For all file sizes for the design: https://a360.co/2SCDNwc