The Jiro Store
Jiro racer
Item List
-
Jiro racer's Top plate
Quantity :1
-
Jiro racer's Lipo plate
Quantity :1
-
Jiro racer's Main plate
Quantity :1
-
Jiro racer's Arms
Quantity :4
-
30mm M3 F/F Alumi Tapped Stepped Standoff Black Anodized 6.3mm O.D.
Quantity :4
-
M3 Nylon Nuts (per piece)
Quantity :8
-
6mm M3 M/F Nylon Standoff (per piece)
Quantity :4
-
7mm M3 Steel Button Head Bolt Black Anodized
Quantity :4
-
12mm M3 Steel Button Head Bolt Black Anodized
Quantity :4
-
8mm M3 Steel Button Head Bolt Black Anodized
Quantity :4
Description
This the Jiro racer frame, build for lightness and strenght. It's a 3 inches, 130.
The arms are separate of the main plate to replace them easily and cheap.
Weight : 33g
Motor's holes spacing : 9mm
Fc's holes mounting : 20mm
Weight with electronics and battery (rcx 1105, micro swift, atx 03, littlebee 6a...) : 125g
Additional Information
To build:
put in the respective order on the 12mm M3 screws, the lipo plate, the M3 nylon nuts.
Then put the 8mm M3 screws in the holes turned inwards on arms, pass the same screws in the main plate and tighten with the M3 6mm nylon standoffs.
After that, put the lipo plate with 12mm M3 screws that you make previously in the holes outwards on arms and main plate and tighten with the M3 30mm alumi standoffs.
Finally, put the top plate on the alumi M3 standoff with M3 7mm screws.
Good flights.
Review Section ( Total Review:0 )
No Review Found
